[. . . ] If your TV goes into Stand-By mode when the key pressed then your remote control has found a compatible code. If certain functions are not working correctly then restart the process moving onto the next code number as this may well improve the situation. If the codes in the list fail to operate your TV then next move onto the automatic code scan function (see below). Easy programming for the control of your AMPLIFIER To programme the remote control to operate your AMPLIFIER, proceed as described for the CD PLAYER. [. . . ] If your TV switches into Stand-By mode during the automatic process then immediately remove your finger from the key and then press and release the TV key until the LED flashes twice, this will then store the code that the remote has found F. In some cases during the automatic scanning search the remote control might find several codes that appear to operate your TV etc, however, if some of the buttons fail to work properly then it’s possible the remote has found a partially compatible code. In such cases you will need to restart the automatic scanning process (steps B. Please note that once the automatic process is restarted, the remote continues from the last stored code and not at the beginning of code database. Adjusting brightness / colour / contrast / bass / tremble / balance at your TV set, using the universal remote control: 1. Within 5 seconds, press 1 for brightness, 2 for colour, 3 for contrast, 4 for tremble, 5 for bass, 6 for balance. After 5 seconds, your remote control returns to standard mode for the selection of channels. Finding out what code number you are using If you have programmed your remote control by means of the automatic code scan, or if you have forgoten the code you have stored then the following procedure will replay the codes being used. This number corresponds to the second digit of the code (if the digit is 0, the LED does not flash). This number corresponds to the third digit of the code (if the digit is 0, the LED does not flash). To read the currently used code for the control of a VCR, SAT, DVD/AUX, CD, TAPE, TUNER or AMP device, proceed as described above for your TV SET. If the codes in the list fail to operate your TV then next move onto the automatic code scan function (see below). Easy programming for the control of your AMPLIFIER To programme the remote control to operate your AMPLIFIER, proceed as described for the CD PLAYER. Please ensure that you refer to the codes listed under the AMPLIFIER section and not CD PLAYER section. Code scan If programming using the codes in the enclosed list failed to work then you must next try the automatic code scan. Ensure that the remote control is equipped with 2 new batteries (see step one of easy programming procedure). When using the automatic scan function for the VCR, DVD, CD or TAPE, switch on your device, insert a video tape, DVD, CD or tape cassette and put the unit into ‘Play mode’ i. After seeing the 2 flashes and within 5 seconds, enter the code 0 0 1 . After entering the code the LED will flash twice indicating that the code has been accepted E. During the automatic scanning you can remove your finger or change hands provided it is replaced within 8 seconds. If left off of the key for more than 8 seconds then the remote will revert back to its normal mode. If your TV switches into Stand-By mode during the automatic process then immediately remove your finger from the key and then press and release the TV key until the LED flashes twice, this will then store the code that the remote has found F. [. . . ] This number corresponds to the second digit of the code (if the digit is 0, the LED does not flash). This number corresponds to the third digit of the code (if the digit is 0, the LED does not flash). To read the currently used code for the control of a VCR, SAT, DVD/AUX, CD, TAPE, TUNER or AMP device, proceed as described above for your TV SET. Complete steps A to F, pressing the VCR , SAT , DVD , CD , TAPE , TUNER or AMP key respectively. [. . . ]